production_run
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
production_run [2020/11/08 12:31] – admin | production_run [2022/09/28 17:23] (current) – admin | ||
---|---|---|---|
Line 1: | Line 1: | ||
[[bilayer_simulations]] | [[bilayer_simulations]] | ||
- | ==== Production run instructions for DT2 ==== | + | ==== Production run instructions for Zaratan |
- | Listed below are some instructions for the production run simulation on DT2 (slight differences for MARCC). As we discussed, this will automatically run your simulation in chunks with each being a certain length. | + | Listed below are some instructions for the production run simulation on Zaratan. As we discussed, this will automatically run your simulation in chunks with each being a certain length. |
- | for DT2, **/homes/ | + | **/home/ |
Line 16: | Line 16: | ||
- Also there is a line with set simt = 1000000. This is to run 1 Million steps of 2ns per block (with 2fs timesteps). | - Also there is a line with set simt = 1000000. This is to run 1 Million steps of 2ns per block (with 2fs timesteps). | ||
- | You then will need to adjust dyn-1.inp and dyn-2.inp to match with what step7_production.inp has. This file will be combined into a dyn.inp file with the firsttimestep defined (see dyn.csh file). | + | You then will need to adjust dyn-1.inp and dyn-2.inp to match with what step7_production.inp has. These files will be combined into a dyn.inp file with the firsttimestep defined (see dyn.csh file). |
Note: dyn-1.inp inputname should stay as dyn | Note: dyn-1.inp inputname should stay as dyn |
production_run.1604856676.txt.gz · Last modified: 2020/11/08 12:31 by admin